PRS-DL Single roll type
In the lathe, by changing the shape of the head roller, the outer diameter can be processed, end, Rside, inner and outer seal groove surface, inclined, the end face of the mirror roll. Note: The tool can ...
показувати:
Сторінка 1 з 1
продам
900 $
1
продам
400 $
1
PRS-TS Stepped diameter
Processing Case: cylinder rod, such as a stepped diameter shaft pin.
продам
400 грн.
1
PRS-TS Stepped diameter
Processing Case: cylinder rod, such as a stepped diameter shaft pin. workpiece diameter（mm）3-1011-2021-3031-5051-7071-100Reserve rolling capacity（mm）0.003-0.020.003-0.020.003-0.020.003-0.020.003-0.020.003-0.02rotate speed ...
продам
400 грн.
4
PRS-TK Through Hole
Processing Case: cylinder block, connecting rod, valve, rocker, and other through-hole rotor…Using the method and processing conditions: 1 push down a graduated aluminum, rotating around the same time, adjust ...
продам
350 $
1
PRS-MK Blind hole
Processing Case: Bearing file, brake pump, pistons,ets.Using the method and processing conditions: 1 push down a graduated aluminum, rotating around the same time, adjust the tool diameter, each scale is ...
продам
400 $
2
PRS-TK Through Hole
处理案例：缸体，连杆，气门，摇臂，以及其他通孔转子... 使用该方法和加工条件： 1下推毕业铝，大约在同一时间旋转，调整刀具直径，每个刻度为0.0025毫米，调节范围0.5毫米。 2刀具夹紧在钻，车，铣，镗数控车床，加工中心的主轴或刀座。工具旋转工件不动右旋转处理。工具也可以固定的，旋转的孔重合的工件的切削加工，工具和加工中心。 3，必须具有对工件的足够的厚度，一般不应超过孔径的15％，如果该壁过薄，壁厚应滚动或以支持外围设备类型帧之前降低。 4根据机床选择的刀具夹持形状部（直柄，莫氏锥柄，BT的处理等）。 ...
Сторінка 1 з 1
оголошень на сторінці